Simple origami dustpan DIY
This origami dustpan can be used to help you sweep up a messy floor or can be used to store papers and other light objects. You should be able to complete this beginner level project in less than five minutes. To achieve the desired dimensions, experiment with a range of paper sizes.
This dustpan, like most other origami models, is folded from a piece of paper that has been pre-cut into a true square. If the dimensions of the square are not accurate, then your model will not fold correctly. For practice, use a square cut from a standard sheet of copy paper. For a large, functional dustpan, you may want to use a square cut from a large sheet of newsprint
The only other thing you’ll need to have before you start folding is a suitably hard, flat surface (table, floor, etc.)upon which to fold. Folding against this type of surface will allow you to make the accurate folds and sharp creases needed for a successful model. Run a ruler or pencil edge over each crease as you work for even sharper creases.
Follow these instructions
- Position a square of paper on your work surface so that its points are facing up and down, left and right. If you are using two-sided paper, make sure that the color you want for the exterior of the dustpan is facing down.
- Bring the top point of the model down to meet the bottom point. Crease and unfold.
- Bring the left point over to meet the right point. Crease and unfold.
- Bring the top point down to the center of the model. Use the intersection of crease lines created in Steps 2 and 3 as a guide. Crease and leave folded.
- Repeat Step 4 for the left, right, and bottom points of the model.
- Bring the top edge of the resulting square shape down to the center of the model. Use the intersection of points created in Steps 4-5 as a guide. Crease and unfold.
- Repeat Step 6 for the bottom edge of the model.
- Bring the left edge of the model over to the center. Use the intersection of points created in Steps 4-5 as a guide. Crease and leave folded.
- Repeat Step 8 for the right edge of the model.
- Bring the top edge of the resulting rectangle down to meet the model’s center horizontal crease line. Crease and unfold.
- Bring the top edge of the model down to meet the bottom edge. Crease and leave folded.
- Open up the top layer of the model just a bit and grasp the left rectangular flap at its midpoint. Bring this midpoint up and to the left to meet the first crease line down from the top edge at the model’s left edge. The upper left corner of the model should begin to rise. Hold in place.
- Repeat Step 12 for the right side of the model. As a result, the top edge of the model should come completely off your work surface and the bottom half of the model should open up.
- Tuck the top edge of the model down into the center to complete the dustpan.